Текст страницы
6. Roller brush cover installation and disassembly.
- Installation: Press the thumb and index finger on both ends of the brush cover to release
the button and press down, and hear the "click" sound to indicate successful installation.
- Disassembly: Press the thumb and index finger on both ends of the release button to lift
up and remove the roller brush cover.
7. Roller brush installation and disassembly.
- Installation: Hold the right end of the brush by hand, align the left side of the brush with
the left end cover, press the brush puller and hear the "click" sound to indicate successful
installation.
- Disassembly: Press the button shown, the brush puller pops out, pull out the brush puller
with your fingers to pull out the brush.
Filling up the Clean Water Tank
1. The cleaning water tank is located on the back of the main body. Grasp the top
of the water tank with your fingers and pull it upwards to remove it.
2. Unscrew the water cap counterclockwise as below and add some water, then screw
it and insert the clean water tank into the cleaner.
• Do not tighten the cover too tightly or too loosely, otherwise the cover may be
damaged or the water tank may leak.
• The user can also add some non-corrosive or flammable liquid cleaning solutions
to clean the floor, do not add dirty water to the cleaning water tank.
8