Текст страницы
True Wireless Earbuds with Active Noise Cancellation
X3 Pro
Manual
EN 1. Power ON/OFF
1s
Take out or place in both earbuds to power on/off.
2. First pairing
Bluetooth
EDIFIER X3 Pro
1. Once powered on, the earbuds will automatically enter Bluetooth pairing mode. 2. Select "EDIFIER X3 Pro" from your device list to connect.
3. Pairing for new device
Bluetooth
EDIFIER X3 Pro
A
Bluetooth
EDIFIER X3 Pro
B
1. Once powered on, the earbuds automatically reconnect to the
last device used.
2. If the connection fails, the earbuds enter Bluetooth pairing mode
in 10 seconds.
3. If manually disconnected, the earbuds enter pairing mode
immediately.
4. Select "EDIFIER X3 Pro" from new device's list to connect.
4. Multipoint connection
①
Bluetooth
EDIFIER X3 Pro
A
②
Bluetooth
EDIFIER X3 Pro
A
③
Bluetooth
EDIFIER X3 Pro
B
Bluetooth
EDIFIER X3 Pro
A
1. While the earbuds are paired, disconnecting them from device A
will auto-enter Bluetooth pairing mode.
2. Go to device B settings and select "EDIFIER X3 Pro" from the
product list to connect.
3. Select "EDIFIER X3 Pro" from the list on device A to reconnect.
Note: For subsequent use, the earbuds will automatically reconnect
to the two devices used last time.
5. Reset/left & right connection
The left and right earbuds are connected by default. If the left and
right earbuds are disconnected, follow the steps below to re-pair:
1. Take out the earbuds;
2. Respectively tap the left and right earbuds 5 times in 8 seconds
to reset and enter TWS pairing, white LED will blink slowly.
3. After reset and TWS connection are successful, the earbuds will
enter Bluetooth pairing mode, white and green LED will blink rapidly.