Текст страницы
10
11
EN
EN
It is normal
take the unit and the batteries to specialized stations for
further recycling.
Water leaks from
the steam release
openings
During heating the
pressure in the steam
chamber increases
and water drops can
appear in the steam
release openings
• Do not use abrasive cleaners and solvents to clean
the garment steamer.
• Do not immerse the garment steamer, the power cord
(9) and the power plug (9) into water or any other
liquids.
The waste generated during the disposal of products
is subject to mandatory collection and consequent
disposal in the prescribed manner.
It is normal
STORAGE
Boiling of water in
the steam chamber is
accompanied with a
corresponding sound
and slight vibration
For further information about recycling of this product
apply to a local municipal administration, a household
waste disposal service or to the shop where you
purchased this product.
A sound of boiling
water inside the
garment steamer
and slight vibration
of the garment
steamer body
DELIVERY SET
• Unplug the garment steamer and wait till it cools
down completely.
• Clean the garment steamer.
• Keep the unit in a dry cool place out of reach of
children and disabled persons.
Troubles and troubleshooting
The manufacturer reserves the right to change the
design, structure and specifications not affecting
general principles of the unit operation, without prior
notice.
1.
Garment steamer – 1 pc.
2.
Brush attachment – 1 pc.
3.
Manual – 1 pc.
Malfunction
Possible reason
Solution
The unit operating life is 3 years
TECHNICAL SPECIFICATIONS
- Insert the power plug
into the mains socket
Small amount or
absence of outgoing
steam
The manufacturing date is specified in the serial
number.
- The garment
steamer is not
connected to the
socket
- Press the steam supply
on button until bumping
In case of any malfunctions, it is necessary to apply
promptly to the authorized service center.
- Power supply: 220-240 V, ~ 50/60 Hz
- Rated input power: 1470 W
- Water tank capacity: 250 ml
- Steam release: 20 g/min
- You do not press
the steam supply on
button completely
RECYCLING
- Unplug the unit, remove
the water tank and fill it
with water, then install
the water tank back to
its place
- There is not enough
water in the tank
- The water tank is
not installed correctly
- Make sure that the
water tank is installed
properly
The garment steamer
is not hot enough
Let the garment steamer
heat up a little longer
before the use
To prevent possible damage to the
environment or harm to the health of
people by uncontrolled waste disposal,
after expiration of the service life of the
unit or the batteries (if included), do not
discard them with usual household waste,
When the steam
supply is switched
on, water leaks from
the steam release
openings