Текст страницы
8
EN
ATTENTION! Do not plug the steamer into the mains
if the water tank (1) is empty.
switch the steamer on again, press the steam
supply button (3) again and wait for the operating
surface (4) to heat up.
USING THE BRUSH ATTACHMENT
ATTENTION! Before installing the brush (10), make
sure that the plug of the power cord (8) is not
inserted into the mains socket.
• Place the steamer on the base (9) on the flat and
stable surface.
• Insert the plug of the power cord (8) into the mains
socket, the indicator (5) will light up, wait for some
time (from 3 to 5 minutes) necessary for normal
steam generation.
• Take the steamer in your hand and hold it by the
handle (7) at the level of the steam supply button (3).
• To switch on the continuous steam supply, press the
button (3) and slide it down until it stops (Fig. 2).
• To switch off the continuous steam supply, press the
button (3) and slide it upwards.
• Before the main use of the steamer, clean the steam
chamber by directing the released steam onto the
fabric, for example, try to smooth out a kitchen towel.
• If the tank (1) runs out of water during operation,
switch the steamer off before filling the tank (1) with
water, to do this, unplug the power cord (8) from the
mains socket.
• After finishing work, unplug the power cord (8) from
the mains socket and let the steamer cool down.
Notes:
• Install the brush attachment (10) on the steamer.
• Open the water inlet lid (2). Fill the tank (1) with
water, not exceeding the MAX mark, and tightly close
the water inlet lid (2) (Fig. 1).
• Do not pour carbonated water, perfumed additives,
vinegar, chemicals, etc. into the tank (1).
• Place the steamer on the base (9) on the flat and
stable surface.
• Insert the plug of the power cord (8) into the mains
socket, the indicator (5) will light up, wait for some
time (from 3 to 5 minutes) necessary for normal
steam generation.
• Take the steamer in your hand and hold it by the
handle (7) at the level of the steam supply button (3).
• Hang the clothes on a hanger.
Note: do not steam clothing while it is being worn, as
the temperature of the released steam is high, use only
hangers.
• To switch on the continuous steam supply, press the
button (3) and slide it down until it stops (Fig. 2).
-
when you switch it on for the first time, an
extraneous smell may appear, this is normal;
-
after 8 minutes, when operating in the steam
supply mode, the steamer will be automatically
switched off, while the indicator (5) will flash, to