Текст страницы
GB
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Warning:
The vibration and noise emission levels may
vary from the level specifi ed during actual use,
depending on the way in which the power tool is
used, especially the type of workpiece it is used
for.
Mains voltage: ...................220-240 V ~ 50/60 Hz
Power input: .............................................. 950 W
Idling speed: ........................................0-990 rpm
Blow rate: ..........................................0-4600 rpm
Drilling capacity in concrete/stone (max.): 28 mm
Protection class: .......................................... II /
Weight: .......................................................4.5 kg
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
LpA sound pressure level ........................ 94 dB(A)
KpA uncertainty .............................................3 dB
LWA sound power level ......................... 105 dB(A)
KWA uncertainty .............................................3 dB
The hammer drill is not designed for outdoors
use as specifi ed I Article 3 of Directive 2000/14/
EC_2005/88/EC.
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment’s construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
5. Before starting the equipment
Hammer drilling in concrete
Vibration emission value ah,HD = 13.0 m/s2
K uncertainty = 1.5 m/s2
Chiseling
Vibration emission value ah,CH = 15.0 m/s2
K uncertainty = 1.5 m/s2
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
The stated vibration emission levels and stated
noise emission values were measured in accord-
ance with a set of standardized criteria and can
be used to compare one power tool with another.
- 14 -
Anl_TC-RH_28_3F_SPK13.indb 14
Anl_TC-RH_28_3F_SPK13.indb 14
23.10.2023 07:58:49
23.10.2023 07:58:49