Текст страницы
14-6. Ring
15-1. Hex wrench
16-1. Dust nozzle
16-2. Screw
17-1. Vacuum cleaner
17-2. Hose
19-1. Clamping lever
19-2. Rip fence (Guide rule)
20-1. Adjusting screw for 45 ﾟ
20-2. Adjusting screw for 0 ﾟ
21-1. Triangular rule
22-1. Base
22-2. Screw
22-3. Saw blade
23-1. Limit mark
24-1. Screwdriver
24-2. Brush holder cap
11-1. Mounting shaft
11-2. Inner flange
11-3. Saw blade
11-4. Outer flange
11-5. Hex bolt
12-1. Inner flange
12-2. Saw blade
12-3. Outer flange
12-4. Hex bolt
13-1. Mounting shaft
13-2. Inner flange
13-3. Saw blade
13-4. Outer flange
13-5. Hex bolt
14-1. Mounting shaft
14-2. Inner flange
14-3. Saw blade
14-4. Outer flange
14-5. Hex bolt
ENGLISH (Original instructions)
Explanation of general view
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Battery indicator
2-2. Overheat indicator
3-1. Star marking
4-1. Lever
5-1. Front lever
6-1. Rear wing nut
7-1. Stopper
8-1. Cutting line (0 ﾟ position)
8-2. Cutting line (45 ﾟ position)
8-3. Screw
9-1. Switch trigger
9-2. Lock-off lever
10-1. Hex wrench
10-2. Loosen
10-3. Tighten
10-4. Shaft lock
SPECIFICATIONS
Model
DHS710
Blade diameter
185 - 190 mm
at 0°
66 - 68.5 mm
at 45°
47.5 - 49 mm
Max. cutting depth
at 50°
42.5 - 44 mm
No load speed (min-1)
4,800
Overall length
356 mm
Net weight
4.7 kg
Rated voltage
D.C. 36 V
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
ENG900-1
Vibration
The
vibration
total
value
(tri-axial
vector
sum)
determined according to EN60745:
Work mode : cutting wood
Vibration emission (ah,W) : 2.5 m/s2 or less
Uncertainty (K) : 1.5 m/s2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
ENE078-2
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece. With
appropriate Makita genuine saw blades, other materials
can also be sawed.
ENG905-1
Noise
The
typical
A-weighted
noise
level
determined
according to EN60745:
Sound pressure level (LpA) : 85 dB (A)
Sound power level (LWA) : 96 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
4