Текст страницы
ENGLISH (Original instructions)
SPECIFICATIONS
Model
LC1230
Blade diameter
305 mm
Hole (arbor) diameter
25.4 mm
Max. kerf thickness of the saw blade
2.5 mm
No load speed
1,700 min
-1
Dimensions (L x W x H)
516 mm x 306 mm x 603 mm
Net weight
19.2 kg
Safety class
/II
•
Due to our continuing program of research and development, the specifications herein are subject to change without notice.
•
Specifications may differ from country to country.
•
Weight according to EPTA-Procedure 01/2014
Cutting capacity
B
A X B
Workpiece shape
A
A
Cutting angle
90°
115mm
75 mm x 150 mm
100 mm x 100 mm
45°
90mm
85 mm x 85mm
Symbols
Intended use
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
The tool is intended for cutting in mild steel and stain-
less steel with appropriate saw blades.
Read instruction manual.
Power supply
DOUBLE INSULATION
Wear safety glasses.
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Do not place hand or fingers close to the
blade.
To avoid injury from flying debris, keep hold-
ing the saw head down, after making cuts,
until the blade has come to a complete stop.
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.25 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
Noise
Only for EU countries
Do not dispose of electric equipment together
with household waste material! In observance of
the European Directive, on Waste Electric and
Electronic Equipment and its implementation
in accordance with national law, electric equip-
ment that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility.
The typical A-weighted noise level determined accord-
ing to EN62841-3-10:
Sound pressure level (LpA) : 107 dB(A)
Sound power level (LWA) : 115 dB (A)
Uncertainty (K) : 3 dB(A)
5
ENGLISH