Текст страницы
17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
17.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Display
Description
E05
Overheating Protection: This means that the temperature had increased to a
temperature of 270°C. In this case the device turns off automatically in order to
avoid damages. In case of “E05” please pull the power plug in order to reset
the device. After this you can use it again as usual.
E09
External thermometer was removed during operation. The device turns off
E0A
External thermometer does not measure temperature increase although device
is heating continuously. Device turns off after a few minutes. Switch the device
on again. Insert the external thermometer into the cooking vessel or food.
Please note
► If error messages continue to be displayed after an extended waiting period or after
restarting the appliance, then it must be sent to Customer Service to be examined.
17.3 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault
Possible Cause
To Rectify
Power plug not plugged in
Insert plug into mains socket
Display is empty
Fuse switch not switched on
Switch on fuse switch
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
18 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
48