Текст страницы
POLISHER SAFETY WARNINGS
TOOL PARTS OVERVIEW
- Use clamps or a vice to secure your work whenever possible.
- Do not apply side pressure to stop the pad rotation after switching the machine off.
- Guide the machine towards the processed material only if the machine is switched on.
•
Position the cord clear of the spinning accessory. If you lose control, the cord may be
cut or snagged and your hand or arm may be pulled into the spinning accessory.
•
Never lay the power tool down until the accessory has come to a complete stop.The
spinning accessory may grab the surface and pull the power tool out of your control.
•
Do not run the power tool while carrying it at your side. Accidental contact with the
spinning accessory could snag your clothing, pulling the accessory into your body.
•
Regularly clean the power tool’s air vents. The motor’s fan will draw the dust inside the
housing and excessive accumulation of powdered metal may cause electrical hazards.
•
Do not operate the power tool near flammable materials. Sparks could ignite these
materials.
•
Do not use accessories that require liquid coolants. Using water or other liquid coolants
may result in electrocution or shock.
- This power tool is designed for dry sanding only.
- The tool must be used only for its prescribed purpose. Any use other use than those
mentioned in this Instruction will be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury resulting from such cases of misuse.
- The manufacturer shall not be liable for any changes made to the tool nor for any damage
resulting from such changes.
- When operating in dusty environment, the ventilation slots must be kept clean. If it should
become necessary to clear dust, first disconnect the tool from the mains supply (use non
metallic objects to clean the dust) and avoid damaging internal parts. The power tool will
overheat under deteriorated cooling due to the clogged with dust ventilation slots.
TOOL PARTS OVERVIEW
1.
On/off switch
2.
Electronic speed preselection wheel
3.
Hook-and-loop flexible backing pad
4.
Hook-and-loop operating tool (soft intermediate disc, abrasive sheet, sponge,
felt wheel, lambswool polishing bonnet)
5.
Spindle lock
EN
6