Текст страницы
OPERATION
MAINTENANCE
OPERATION
SWITCHING ON - SWITCHING OFF
•
Switching on: Push the back end of the ON/OFF switch 1 down and then forward in the
direction of the arrow until its front end will sag, thus fixing itself.
•
Switching off: Press the back, lifted end of switch 1 and release it to return in its initial
position.
Preselecting the speed
•
To set the operating speed, move the dial 2 to the required value.
MOUNTING THE AUXILIARY HANDLE
•
The auxiliary handle 3 is fastened to the gear box by two bolts under the bolt heads.
Screwing and unscrewing the bolts is performed by an open end spanner.
•
The auxiliary handle 4 can be mounted alternatively to the right or left side of the gear
box. It is screwed directly to the machine gear box.
BACKING PAD
•
The backing pad 5 can be screwed directly onto the spindle. The hook-and-loop
operating tools 6 (sandpaper, polishing sponge, felt wheel, lambswool bonnet, etc.)
can be fixed directly onto the backing pad.
•
To dismount (unscrew) the backing pad use a spanner when necessary.
FIXING THE OPERATING TOOL TO THE HOOK-AND-LOOP (VELCRO) BACKING PAD
•
The operating tool fastened to the backing pad shall be Ømin148. The operating tool
shall be aligned with the backing pad and care shall be taken to ensure their coaxiality.
Eccentrically mounted operating tools cause wobbling and vibrations.
•
WARNING: Use only pads with un-damaged hook-and-loop system. Perform a trial test
for at least 30 sec at no load after replacing the backing pad.
•
WARNING: Vibrating or otherwise improperly rotating backing pads must be re-placed
immediately!
MAINTENANCE
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are properly tightened. Should any of the
screws be loose, retighten it immediately to avoid hazards.
If the replacement of the supply cord is necessary, this has to be done by the manufacturer
or his agent in order to avoid a safety hazard.
EN
7