Текст страницы
ENG
Party Speaker System
with Bluetooth and FM-radio
Connecting to the speaker via Bluetooth using NFC
NFС works only with Android devices (version 4.1 and later).
To connect the speaker to a smartphone, the smartphone must be equipped with an NFC chip.
It must be enabled in the wireless settings.
• Turn on the speaker system Bluetooth mode — press button МODE k several times until
display shows “BLUE” inscription.
• Hold the phone close to the NFC mark i on the top panel and wait for a short beep to confirm
a successful speaker connection.
Note. You need to allow connections on the phone (depending on the phone’s operating system).
Radio mode
Attention! To improve the reception quality of the radio signal, connect the 3.5 mm mini-jack
cable (included) to the AUX input f.
• Turn on the speaker system — press button МODE k several times until the display shows
the station frequency. Long-term pressing button o activates auto search mode. After scan-
ning completion, the first scanned radio station will start to operate automatically. With buttons
l and p select a desired radio station.
Player mode
Attention! The file system of a micro SD carrier is FAT32. Maximum volume is 32 GB.
The system will enter the Player mode automatically when a carrier (USB flash or SD card)
is connected to corresponding ports. Use button o to switch between Play/Pause modes.
You can control tracks by using buttons l (previous track) and p (next track). The use in the
wired mode (LINE IN).
• Speaker system can be used as an external device for amplifying any audio source with a 3.5 mm
output mini-jack. Connect a cable mini USB, plug 3.5 mini-jack to the audio input AUX f. Turn
the speakers to the LINE IN mode — press the MODE button k several times until “LINE” appears
on the display.
Connecting an additional speaker
For model PS-850 you can connect an additional speaker.
• For TWS connection in Bluetooth mode:
– Turn both speakers into Bluetooth mode (both speakers should be in search mode).
– On another speaker press and hold button MENU j on control panel or TWS button f
on Remote control.
– If two speakers are successfully connected between themselves, the master unit will display
“BLUE” constantly, the slave unit will display “SLAU”.
– Connect the signal source via Bluetooth. Both speakers will appear in the search list as one
device.
• For connection in other modes (FM radio/Player/LINE IN):
– on any speaker, press and hold the MENU button j on the control panel or the TWS button
f on the remote control.
– If two speakers are successfully connected to each other, the operating mode will be displayed
on the master device, and “SLAU” will be displayed on the slave device.
Reset
To reset the settings, long press the VOL q on control panel or the RESET n on remote control.
Settings will reset.