Текст страницы
NAVITEL PWR10 MX BLACK | 7
Before you start using
- Charge the power bank fully before use.
- Check the battery level. To do this, press Check button on the device body. The display will show a number that indicates the battery
charge level 0-100%
3. Connect the supplied charging cable to a power source and connect to the USB-C input port on the device.
4. The digital battery indicator flashes while charging and stops flashing when the battery is fully charged
EN
Charging electronic devices
- Connect the power cable to the device to be charged.
- Connect the other end of the power cable to the USB-C or USB-A output of the charger.
- Digital Battery Indicator will illuminate when charging.
- Disconnect the power cord after charging
Precautions
When using the product, be sure to observe the following precautions:
• Read the manual carefully before using the device.
• Charge the power bank fully before use. The full performance of the device is only achieved after two or three complete charge and
discharge cycles.
• Do not disassemble or repair device by yourself. In case of device failure, contact the service center.
• Do not expose the device to moisture.
• Do not use the device more than its output rating. Overload outputs above rating may result in a risk of fire or injury.
• Do not use the device if damaged or modified
• Do not expose the device to fire or high temperature. Exposure to fire or temperatures above 100 ºC may result in an explosion.