Текст страницы
4 | USER MANUAL
Before you start using
EN
1. Charge the power bank fully before use.
2. Check the battery level. To do this, press Check button on the device body. The display will show a number that indicates the battery
charge level 0-100%
3. Connect the supplied charging cable to a power source and connect to the Type-C input port on the device.
4. The digital battery indicator flashes while charging and stops flashing when the battery is fully charged.
Charging electronic devices
- Connect the power cable to the device to be charged.
- Connect the other end of the power cable to the Type-C or Type-A output of the charger.
- Digital Battery Indicator will illuminate when charging.
- Disconnect the power cord after charging.
Precautions
When using the product, be sure to observe the following precautions:
• Read the manual carefully before using the device.
• Charge the power bank fully before use. The full performance of the device is only achieved after two or three complete charge and
discharge cycles.
• Do not disassemble or repair device by yourself. In case of device failure, contact the service center.
• Do not expose the device to moisture.
• Do not use the device more than its output rating. Overload outputs above rating may result in a risk of fire or injury.
• Do not use the device if damaged or modified
• Do not expose the device to fire or high temperature. Exposure to fire or temperatures above 100 ºC may result in an explosion.