Текст страницы
INSTALLATION OF TELESCOPIC TUBE AND ATTACHMENTS (BRUSHES)
Attach the tube to the
handle
Adjust tube length
Attach the desired
attachment to the tube
CLEANING OF NON-WOVEN AND HEPA FILTERS
The filters should be cleaned after each use of the vacuum cleaner. Shake the filters to
remove dust. In addition, approximately once a month with an average intensity of use,
they must be blown through with a powerful jet of air. Do not wet the HEPA=filter - this
can lead to failure of the electric motor! If you use your vacuum cleaner moderately,
replace the non-woven and HEPA filters every 6 months.
ATTENTION!
Replacement filter sets can be purchased separately. We strongly recommend observing
these maintenance requirements, as this will allow retaining the highest suction capacity
and proper operation of your CENTEK vacuum cleaner for a long time. This is also an
obligatory condition for guarantee maintenance.
OPERATION START
1. Prior to operation start pull out the power
cable to the desired length and insert the
plug into the power socket. do not pull out
the cable beyond the red mark. To retract
the cable press the wind up while holding
the cable with your hand for safety.
2. Turn the vacuum cleaner on and off by
pressing the on/off button.
ATTENTION!
- Do not wash the filters in a washing machine and do not dry them with a hair dryer
or other heating devices.
- Do not operate the vacuum cleaner without filters installed, as this may damage
the motor.
USING THE ATTACHMENTS
1
TWO-POSITION BRUSH FOR FLOOR AND CARPETS
Pos. 1: brushes extended – for solid floors.
Pos. 2: brushes retracted – for carpet cleaning.
- SPECIFICATION
- Nominal power rating: 2000 W
- Max power rating: 2400 W
- Suction capacity: 420 W
- Nominal rated voltage: 220-240 V ~50/60 Hz
DUST COLLECTOR CLEANING
- Press the dust collector lock button and remove it.
- Open the bottom cover of the dust collector, remove the plastic filter from the dust
collector.
- Remove dust and debris from the dust collector.
- Wipe the housing and holes in the walls of the plastic filter with a cloth cloth.
- Install the plastic filter in the dust collector.
- Install the dust collector back on the body of the vacuum cleaner.
2
SLOT BRUSH
For cleaning heating radiators, corners, tight spaces, drawers,
etc.
7. DISPOSAL
Upon expiry of its service life the appliance can be disposed of separately from ordinary
domestic waste. You can turn it over to a specialized electric and electronic appliance
disposal and recycling centre.
5. MAINTENANCE
Your vacuum cleaner is equipped with 2 types of filters:
1. Inlet filter made of non-woven fiber.
2. Output HEPA filter.
Each of these filters requires maintenance and regular replacement.
8. CERTIFICATION DATA, GUARANTEE
The service life of this item is 5 years since the date of sale to the end user, provided
the item will be used in strict accordance with the present manual and the applicable
technical standards. Upon expiry of the service life please contact the nearest
17