Текст страницы
button (H).
Wash the suction nozzle with water.
Re-install the nozzle, tightening it until it clicks into
place.
CLEANING THE DIRTY WATER TANK FILTER:
Pull the handle to release the dirty water tank.
Remove dirt and debris from the filter screen
located under the dirty water tank.
CONSUMABLES:
You can purchase consumables (e.g. brush,
nozzle) from the official Taurus website.
Always use original consumables, specifically
designed for your appliance model.
TROUBLESHOOTING
PROBLEM
CAUSA
SOLUTION
The device does not work
The power cord is not
plugged in.
Check that the power cord
is plugged in.
The motor thermostat
may have tripped.
Unplug the unit. Check the
appliance for blockages
and clean the filter
screen.
The device does not
vacuum
The nozzle must not be in
contact with the surface.
Tilt the nozzle forward.
The dirty water tank is full.
Empty the dirty water tank.
Check the filter screen for
dirt and debris.
The filter located under
the dirty water tank is
clogged.
Water dispenser does not
work
You are not pressing
button (A).
Press button (A) to release
the soap and water
mixture.
The clean water tank is
not properly installed.
Place the clean water tank
correctly.
The fresh water tank is
empty.
Fill the tank with water and
soap.
Air has been trapped
between the pump and
the hose.
Turn on the unit, prime
the pump by lowering
the hose to the ground
and hold the trigger for 1
minute.
The clean water tank
valve may be clogged.
Hold the tank over the
sink and press the valve
underneath to release it.