Текст страницы
EN
6 Connect the power adapter h to the port on
the back of the charging station.
EN
4 Slide the detachable nozzle storage d or
detachable nozzle and mop pads storage e
onto the floor stand pipe.
•• This accessory is only available on some
models.
•• Attach the detachable mop pads storage
f module onto the detachable nozzle
storage module, if they did not come
pre-assembled. Once assembled, the
two modules may be difficult to be
disassembled.
•• Make sure not to pinch or tangle the power
cord behind the mop pads storage.
7 Drill a hole and insert the drywall anchor i.
•• Before drilling, make sure that there are no
pipes or electrical wires inside the wall at
the desired location.
•• For drywall anchor: use 6.5 mm drill bit
•• Recommended diameter of hole: 6.5 mm
•• Recommended depth: 60 mm
•• If screwing into drywall, the drywall anchor
should be used.
5 Assemble the charging station g onto the top
of the floor stand pipe.
•• The charging station can be removed as
needed. To remove it, hold the floor stand
dock steady and pull up on the charging
station.
17