Текст страницы
ENGLISH
••
Close the dustbag compartment lid (12),
slightly press on the lid (12) until locking (10).
Note:
– do not try to close the lid (12) without the dust
immediately and check the telescopic pipe (4)
or the flexible hose (7) for obstruction. Switch
the vacuum cleaner off, unplug it, remove the
obstruction and only after that you can con
tinue cleaning.
bag holder installed, otherwise you can dam
age the locking system;
– always make sure that the dustbag holder
and the dustbag (20 or 21) are installed prop
erly before closing the dustbag compartment
lid (12).
OPERATION
Attention! Switch the vacuum cleaner on only
with the dustbag (20 or 21) and the outlet fil
ter installed. Always make sure that the filter is
installed properly.
FILTER CLEANING
Keep the outlet HEPA filter (22) clean because
the overall performance of the vacuum cleaner
depends on it; clean the filter no less than 3-4
times a year, and more often at severe obstruc
tion.
Cleaning the outlet HEPA filter (22)
••
Before using the unit, unwind the power cord
to the required length and insert the power
plug into the mains socket.
••
The yellow mark on the power cord indicates
the maximum cord length. Do not unwind the
power cord further than the red mark.
••
Press the ON/OFF button (13) to switch the
vacuum cleaner on.
••
You can adjust the suction power during oper
ation with the manual suction power con
trol (5).
••
After room cleaning switch the vacuum cleaner
off by pressing the ON/OFF button (13) and
unplug the unit.
••
To wind the power cord (17), press the power
cord winding button (15); hold the winding
cord with your hand to avoid its whipping and
damage.
••
Switch the vacuum cleaner off and unplug it.
••
Remove the outlet filter grid by pressing the
lock and remove the HEPA filter (22).
••
Wash the HEPA filter (22) under slightly warm
water jet. Do not wash filters in a dishwash
ing machine.
••
Dry the HEPA filter (22). Do not dry the HEPA
filter (22) with a hairdryer.
••
Install the HEPA filter (22) back to its place.
••
Install the outlet filter grid back to its place.
Notes:
– Before installing the HEPA filter (22) make
CLEANING AND CARE
sure that it is clean and dry.
– Do not dry the HEPA filter (22) with a hairdryer.
Vacuum cleaner body
– Wipe the vacuum cleaner body with a soft,
••
If the full dustbag indicator (16) turns «red»
during the vacuum cleaner operation, replace
the paper (21) dustbag or clean up the cloth
(20) dustbag.
Note: - the paper dustbag (21) is disposable, dis
pose of the dustbag (21) when it is filled up.
slightly damp cloth and then wipe it dry.
– Do not immerse the body of the vacuum
cleaner, the power cord and the power plug of
the unit into water or other liquids. Provide that
no liquid gets inside the vacuum cleaner body.
– Do not use any solvents or abrasives for clean
ing the vacuum cleaner body and the acces
sories.
STORAGE
••
Before taking the vacuum cleaner away for
long term storage, clean its body, the dustbag
(20) and the filters.
••
You can store the vacuum cleaner both in verti
cal and horizontal position.
••
Keep the unit out of reach of children and dis
abled persons.
••
Before cleaning the cloth dustbag (20) switch
the vacuum cleaner off and unplug it.
••
Open the dustbag compartment lid (12) press
ing on the lid lock (10).
••
Remove the dustbag (20) with the holder.
••
Take the dustbag (20) out from the hol-der.
••
To clean the cloth dustbag (20) place it above
the trash bin and remove the plastic clamp. If
necessary, wash the cloth dustbag (20) with
warm water and neutral detergent and dry
thoroughly, after that install the plastic clamp
back to its place.
••
Install the dustbag (20 or 21) into the holder.
••
Install the holder (19) with the dustbag (20 or
21) to the installation place.
10