Текст страницы
② Receiver
2. Charge
Caring For Your SYNCO Product
Product Introduction
Working Indicators (White Light) On： Flash：
1. TX Transmitter
Slow Flash
Unpaired
Transmitter：
Charge the transmitter via the Type-C charging
port and charging cable.
1~5 indicators on
Connected and working normally.
The number of lights on indicates the
current volume
① Power Key
② Working Indicator
③ Built-in Microphone
④ Back Clip
⑤ Type-C Charging Port
Mute on
Single indicator flashed
slowly
2. RX Receiver
Mobile Phone :
Insert your phone's charging cable into the Type-C port of the
receiver when in use, and the charging current is adjusted according
to the phone's battery max up to 800mA.
*Note: The receiver does not need to be charged and can be used
directly when plugged in the phone.
Lightning Connector
· Please keep the product in a dry, clean, dust-free environment.
· Keep corrosive chemicals, liquids and heat source away from the
product to prevent mechanics damage.
· Use only a soft and dry cloth for cleaning the product.
· Malfunction may be caused by dropping, impact of external force.
· Do not attempt to disassemble the product. Doing so voids
warranty.
· Please have the product checked or repaired by authorized
technicians if any malfunctions happened.
· Failure to follow all the instructions may result in mechanics
damage.
· Warranty does not apply to human errors.
① Volume Button
② Type-C Port
③ Working Indicator
④ Connector
Operations
Type-C Connector
1. Turn On/Off
Package List
3. Indicator
* Note：The indicator identification shown as follows.
Left
Right
①Transmitter: Long press the power button of the transmitter for 3
seconds.
*Note：The transmitter will shut down automatically if it is unpaired
or disconnected for 5 minutes.
② Receiver: Insert the mobile phone device to switch on
automatically, and the indicator flashes.
Transmitter x2
Charging cable
x1
① Transmitter
3. Paring
Receiver (Type-C or
Lightning Connector)
x1
Working Indicators (White Light) On： Flash：
Slow Flash
Unpaired
The transmitter and receiver will automatically start pairing once
power on.
*Note: For P2XT/L, each receiver can only pair with two transmitters.
Microphone P2X
User Manual
Illuminate sequentially
Paired, normal working
Mic Windshield
x2
Carrying Bag x1
User Manual x1
Single indicator keeps on
Noise cancellation on
Thank you for choosing SYNCO product. Please read this manual
carefully before use and follow all instructions mentioned herein.