Текст страницы
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
DTM52
Oscillation per minute
10,000 - 20,000 min
-1
Oscillation angle, left/right
1.8° (3.6° total)
Overall length
with BL1820B
305 mm
with BL1860B
322 mm
Net weight
1.7 - 2.0 kg
Rated voltage
D.C. 18 V
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
•
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
Charger
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC18SH
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Applicable application tool
Noise
Use the application tool which type is adaptable to this
tool as shown in the following table.
OIS
The typical A-weighted noise level determined accord-
ing to EN62841-2-4:
Work mode: Sanding
Sound pressure level (LpA) : 69 dB(A)
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
STARLOCK
STARLOCK PLUS
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Work mode: Cutting with plunge cut saw blade
Sound pressure level (LpA) : 72 dB(A)
Uncertainty (K) : 3 dB(A)
STARLOCK MAX
The noise level under working may exceed 80 dB (A).
Intended use
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Work mode: Cutting with segmental saw blade
Sound pressure level (LpA) : 76 dB(A)
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
The tool is intended for sawing and cutting wood,
plastic, gypsum, non-ferrous metals, and fastening
elements (e.g. nails and staples). It is also intended for
working soft wall tiles, as well as dry sanding and scrap-
ing of small surfaces. It is especially for working close to
edge and flush cutting.
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Work mode: Scraping
Sound pressure level (LpA) : 71 dB(A)
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
4
ENGLISH