Текст страницы
Note:
D7 Mop Cloths
D10 Dirty Water Tank
* Clean as required and replace every 1-3 months.
* Clean as required.
Make sure the disposable dust bag is properly
installed to avoid waste escaping and damaging the
dock.
D7-1—Remove the mop cloths from mop
cloth mounts. Clean the mop cloths
and air-dry them.
D12-4—Reinstall the dust container cover
in place and close the dock cover
to make sure the dust container is
securely sealed.
A dirty mop cloth will affect the mopping
performance. Clean it before use.
Note:
Open the dirty water tank lid and pour out
the dirty water. Fill the tank with clean water,
close the lid, lock the latch, and shake. Pour
out the dirty water. Lock the lid and reinstall
the tank.
Notes:
D13 Cleaning Tray Module
D7-2—Stick the mop cloths on the mounts
flat in place.
* Clean as required.
D13-1—Remove the cleaning tray module.
D8 Robot Sensors
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
* Clean as required.
D11 Charging Contacts
* Clean as required.
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
D13-2—Remove the cleaning tray and filter
from the module and then rinse
them with water.
D13-3—Reinstall the filter and cleaning tray.
Then, reinstall the cleaning tray
module.
D12 Replacing Disposable Dust Bag
* Replace as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
D8-1—Dock Locator
D8-2—Reactive AI Obstacle Recognition
Sensor
D8-3—Wall Sensor
D8-4—Communication Sensor
D8-5—Cliff Sensors
D8-6—Carpet Sensor
D9 Moving the Dock
D12-1—Open the dock cover and remove
the dust container cover.
D12-2—Remove the disposable dust bag
and discard it.
Notes:
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before putting back the dust
container cover to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
To move the dock, grip the handle on the
back with one hand and the inner side of the
front board with the other hand. Do not lift
the dock base directly to prevent the dock
from falling off.
D12-3—Clean the filter with a dry cloth,
insert a new disposable dust bag
into the slot all the way in, and
spread it evenly.
39