Текст страницы
B2 Assembly
B2-1—Align and install the mop axles into
the robot in place until you hear a click.
• Maintain the dock according to the Routine
Maintenance. Do not clean the dock power cord and
charging contacts with a wet cloth or tissue.
• All docks are subject to water-based tests before
leaving the factory. It is normal that a small amount of
water remains in the waterway of the dock.
B2-2—Click
B4 Powering On & Charging
B3 Positioning the Dock
A10-14—Drying Air Outlets
A10-15—Dock Location Beacon
A10-16—Suction Inlet
A10-17—Robot Refill Port
A10-18—Cleaning Tray Module
A10-19—Water Level Float
A10-20—Clean Water Dispensers
Installation
B
Press and hold
to power on the robot.
Wait until the power indicator light is steady,
and then place the robot in front of the dock.
Make sure the dock is plugged in. Then, press
B1 Important Information
and the robot will automatically return to
the dock for charging. The robot is equipped
with a built-in high-performance lithium-ion
rechargeable battery pack. To maintain battery
performance, keep the robot charged.
Place the dock on a hard, flat floor (wood/
tile/concrete etc.), flat against a wall, and
reserve a space of at least 0.9 m (2.96 ft)
in height, 0.46 m (1.51 ft) in width and
1.2 m (3.94 ft) in depth. Make sure that the
location has good WiFi coverage for a better
experience with the mobile app. Plug in and
make sure that the status indicator light is
on.
B4-1—Dock status indicator light off, robot
power indicator light breathing:
Charging.
B3-1—More than 1.2 m (3.94 ft)
B3-2—More than 0.9 m (2.96 ft)
B3-3—More than 0.46 m (1.51 ft)
Note:
The robot may not be turned on when the battery
is low. In this case, place the robot to the dock for
charging.
B1-1—Tidy cords, hard or sharp objects
(such as nails and glass), and loose
items from the ground and move
any unstable, fragile, precious, or
dangerous items to prevent personal
injury or property damage due to
items becoming tangled in, struck by,
or knocked over by the robot.
B1-2—When using the robot in a raised
area (such as in a duplex apartment),
always use a physical security barrier
to prevent accidental falls that may
result in personal injury or property
damage.
Notes:
• When using the robot for the first time, follow it
throughout its whole cleaning route and watch for
potential problems. The robot will be able to clean by
itself in future uses.
• To prevent excessive buildup of dirt on the mop cloths,
floors should be vacuumed at least three times before
the first mopping cycle.
Notes:
• If the power cord hangs vertically to the ground, it
may be caught by the robot, causing the dock to be
moved or disconnected.
• The status indicator light is on when the dock is
powered on, and off when the robot is charging.
• The status indicator light turns red if an error occurs.
• Place the dock on a hard, flat floor away from fire,
heat, and water. Avoid narrow spaces or locations
where the robot may be suspended in the air.
• Placing the dock on a soft surface (carpet/mat) may
cause the dock to tilt and cause docking and departing
problems.
• Keep the dock away from direct sunlight or anything
that may block the dock location beacon, otherwise
the robot may fail to return to the dock.
• Do not use the dock without clean water tank, dirty
water tank, dust container cover, disposable dust bag,
or cleaning tray module.
35