Текст страницы
D5 Dustbin
Routine Maintenance
D
* Clean as required.
Note:
The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
D5-1—Remove the magnetic top cover of
the robot and press the dustbin latch
to take out the dustbin.
Notes:
• To securely install the main brush cover, make sure to
press both of the main brush cover latches in place.
• It is recommended to wipe the main brushes with a
wet cloth. If the main brushes are wet, air-dry them
away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to
clean the main brushes.
D1 Main Brushes
* Clean every 2 weeks and replace every 6-12 months.
D5-2—Remove the washable filter and
empty the dustbin.
D2 Side Brush
* Clean monthly and replace every 3-6 months.
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brushes
D1-4—Main Brush Bearing
D5-3—Fill the dustbin with clean water and
reinstall the washable filter. Gently
shake the dustbin, and then pour out
the dirty water.
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
Unscrew the side brush screw. Remove
and clean the side brush. Align the central
groove with the raised position on the
robot, then tighten the screw to reinstall the
side brush.
D3 Omnidirectional Wheel
* Clean as required.
D5-4—Allow at least 24 hours for the dustbin
and washable filter to dry thoroughly
before reinstalling them.
D3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the wheel.
D6 Washable Filter
D1-5—Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D1-6—Lift the main brushes and pull them
out, remove bearings and remove
any entangled hair or dirt at both
ends of the main brushes and
bearings.
* Clean every 2 weeks and replace every 6-12 months.
The omnidirectional wheel bracket cannot be removed.
Note:
D6-1—Remove the filter.
D6-2—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
D1-7—Reinstall the main brush bearings. And
then, reinstall the main brushes and
make sure the color of the main brush,
main brush bearing and the arrow on
the robot match.
D3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
Do not touch the surface of the filter with hands,
brushes, or hard objects to avoid potential damage.
Note:
D4 Main Wheels
* Clean as required.
D6-3—Allow at least 24 hours for the filter to
dry thoroughly before reinstalling it.
Clean the main wheels with a soft, dry cloth.
D1-8— Reinstall the main brush cover. Make
sure its four teeth are fully seated in
the slots, and press the main brush
cover until you hear it lock with a
click.
38