Текст страницы
Notes:
D13 Cleaning Tray Module
A dirty mop cloth will affect the mopping
performance. Clean it before use.
Note:
* Clean as required.
D13-1—Remove the cleaning tray module.
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
D7-2—Stick the mop cloths on the mounts
flat in place.
D8 Robot Sensors
D11 Charging Contacts
D13-2—Remove the cleaning tray and filter
from the module and then rinse
them with water.
* Clean as required.
* Clean as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
D13-3—Reinstall the filter and cleaning tray.
Then, reinstall the cleaning tray
module.
D12 Replacing the Disposable
Dust Bag
Basic Parameters
* Replace as required.
D12-1—Remove the dust container cover.
Robot
D8-1—Reactive Tech Obstacle Avoidance
Sensor
D8-2—Wall Sensor
D8-3—Communication Sensor
D8-4—Cliff Sensors
D8-5—Carpet Sensor
Model
RRE0VCM
D12-2—Remove the disposable dust bag
and discard it.
D9 Moving the Dock
Notes:
Battery
14.4 V/5200 mAh (TYP)
lithium-ion battery
Rated Input
20 VDC 1.5 A
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before putting back the dust
container cover to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
The serial number is on a sticker on the underside
of the robot.
Note:
To move the dock, grip the handle on the
back with one hand and the inner side of the
front board with the other hand. Do not lift
the dock base, water tank handles, or dust
container cover directly to prevent the dock
from falling off.
D10 Dirty Water Tank
D12-3—Clean the filter with a dry cloth,
insert a new disposable dust bag
into the slot all the way in, and
spread it evenly.
* Clean as required.
Make sure the disposable dust bag is properly
installed to avoid waste escaping and damaging the dock.
Note:
D12-4—Reinstall the dust container cover
in place to make sure the dust
container is securely sealed.
Open the dirty water tank lid and pour out
the dirty water. Fill the tank with clean water,
close the lid, lock the latch, and shake. Pour
out the dirty water. Lock the lid and reinstall
the tank.
40