Текст страницы
LED and Button
EN
4. Then please check 4G information card of the status page. If the status
is connected, means connected to the internet successfully.
Name Status Indication
4G
4G
Internet is not connected
Red
Status
Connected
Status
Not connected
4G or WAN Internet is connected
Blue
Solid On
2/3G is Connected
Purple
RSSI
22
RSSI
-
System is starting up
Red
Upload / Download
770.63KB / 681.69KB
Upload / Download
0.00 B / 0.00 B
System
LED
WPS is in progress
Blue
Flashing
More Details
More Details
Software Upgrading
Red-Purple-Blue
Connected
Not connected
Power adapter is not connected to the device.
Off
On
The corresponding ethernet port is connected.
Ethernet
LED
The corresponding ethernet port is not connected.
Off
5. If 4G is not connected, or if you want to customize the router yourself,
click "Quick Setup" and follow the step-by-step instructions to config-
ure the router.
Press and hold 1 second to enable the WPS function.
WPS
Button
Reset
Press and hold this button for about 6 seconds to
reset the router to its factory default settings.
Status
Internet
Not connected
Work Mode
4G Router
Need Help?
Model
LT500
Q1. What should I do if I cannot access the web management page?
Quick Setup
A1: If the computer is set to a static IP address, change its settings to obtain an IP
address automatically.
A2: Make sure http://cudy.net/ or http://192.168.10.1/ is correctly entered in the
web browser.
A3: Use another web browser and try again.
A4: Reboot your router and try again.
A5: Disable and enable the active network adapter in use.
Note：
1, If you are not sure about APN parameters, please contact your internet provider.
2, If you meet any other problems, don't hesitate to contact our technical support
team: support@cudy.com
Q2. How do I restore the router to its factory default settings?
Enjoy the internet!
A1: With the router powered on, press and hold the RESET button for 6 seconds
before release. Wait the router resets.
A2: Log in to the web management page of the router, and go to
Advanced Settings >Reset , click Perform Reset and wait until the reset process is
complete.
— 3 —
— 4 —