Текст страницы
MANUAL
33
EN
5 WORKING PROCEDURE
5 WORKING PROCEDURE
6 MAINTENANCE
6 MAINTENANCE
Before performing any of the following ac
tions, make sure that the switch is in the
OFF position.
6.1 After finishing the work, it is necessary
to clean the product from dust and dirt.
Special attention should be paid to the ven
tilation openings.
To clean the case, do not use cleaning
agents that can cause rust to form on the
metal parts of the product or damage the
plastic surface.
Wipe the body of the product with a damp
soft cloth, then wipe it dry.
6.2 Regularly check the reliability of all
screws. If a loose screw is found, tighten
it immediately. Otherwise, you are putting
yourself at risk of injury.
6.3 After each use, clean the product body
and the knife clamping mechanism regu
larly from dirt with a soft brush and/or com
pressed air. Then wipe the blades with a
cloth and apply chainsaw chain oil or en
gine oil to the edges of the blades and mov
ing parts.
Attention! Do not disassemble the pruner
housing for cleaning. If necessary, contact
an authorized service center.
7 STORAGE RULES
7 STORAGE RULES
The product is designed for use in temper
ate climates at ambient temperatures from
+1 °C to +35 °C and a relative humidity of
no more than 80%. This model of pruner is
equipped with
5.1 Make sure that the switch is in the OFF
position. and the battery of the product is
charged enough to complete the task.
5.2 Check the integrity of the garden tool
and the reliability of all fasteners.
5.3 Perform maintenance on the garden
tool.
5.4 To start operation, briefly press the trig
ger switch twice temporarily. After double
pressing and the sound signal is triggered,
the cutting blades will open and the pruner
will be ready for operation.
5.5 To perform trimming, press the trigger
switch each time to close the cutting blades
and release it so that the blades open.
5.6 This pruner model is equipped with a
function for changing the cutting diameter.
To change the diameter, hold down the
trigger switch. A single beep indicates a
change in the diameter of the cut.
5.7 At the end of operation, to turn off the
pruner, hold down the trigger switch (longer
than for changing the cutting diameter). Af
ter a single beep, continue to hold the trig
ger switch. After three short
-term beeps, the cutting blades will remain
in the closed position.
5.8 To turn off the tool completely, press the
power button, before doing the steps de
scribed in clause 5.
7.1 The product must be stored at an ambi
ent temperature from 0 °C to +40°With and
relative humidity of no more than 80% in a
place inaccessible to children and animals.
7.2 To avoid damage, transport the product
only in its original packaging. After trans
porting or storing the product at a reduced
temperature, it must be kept at room tem
perature for at least two hours.
7.3 During transportation, loading, unload
ing and storage of the product, the follow
ing requirements should be followed, in
addition to those set out in the operating
instructions:
- it is forbidden to expose the product to
significant mechanical loads that may dam