Текст страницы
IM022
Do not use other attachments than those supplied.
In case of power cord is damaged, its replacement should be
done by the manufacture or service department or the other high-skill person to avoid any danger.
Do not attempt to repair, adjust or replace parts in the
appliance. Check and repair the malfunctioning appliance in the nearest service center only.
Keep the cord away from sharp edges and hot surfaces.
Do not pull, twist, or wrap the power cord around the
appliance.
Do not place the appliance near gas or electric oven or store
at heated surface.
Avoid contacting with moving parts.
Do not run juice extractor continuously for longer than 5
minute. Turn off switch and let it rest for at least 2 minute to cool down the motor, otherwise the motor may be damaged.
Always disconnect the appliance from the supply if it is left
unattended and before assembling, disassembling or cleaning If the product has been exposed to temperatures below 0ºC for some time it should be kept at
room temperature for at least 2 hours before turning it on.
The manufacturer reserves the right to introduce minor changes into the product design
without prior notice, unless such changes influence significantly the product safety,
performance, and functions.
Manufacturing date is indicated on the unit and/or on packing as well as in accompanying
documents in the following format XX.XXXX where first two figures XX is the month of
production, and following four figures XXXX is the year of production.
BEFORE USING FOR THE FIRST TIME
The juicer is designed to extract juice from any citrus fruit.
After unpacking the unit and before any use, make sure the mechanical parts of the unit and
all attachments are not damaged.
Wash and dry all parts of the appliance, which will come into contact with products. To clean
the outside of the body use a damp sponge.
WORK
Before assembly make sure that the appliance is switched off and disconnected from mains.
Place the juice collector on the base.
Select the orange cone or lemon cone.
Place the cone into the filter opening.
Place the filter with the cone installed in it on the central axle of the juice collector.
Cut the citrus in half.
Press gently each half to a cone.
Citrus juicer will start automatically.
If you stop pressing the cone, the device will turn off.
When the juicer is working, the cones rotate in both sides. This feature of the device allows
you to get the maximum amount of juice from one fruit.
When process is completed, switch off and unplug the unit.
CLEANING
Remove and wash all removable parts in warm soapy water. Rinse the filter assembly from
under side for easy removal of residue from strainer holes. Do not use a dishwasher or very
hot water.
Do not use steel woods, abrasive cleaners or scouring pad on the appliance.
www.scarlett.ru
SC-JE50C02
4