Текст страницы
AUTOMATIC WASHING MACHINE
- Do not place the product on the power cable.
- Do not install the product in places where the temperature may drop below 0°C.
- Place the product at a distance of at least 1 cm from other furniture.
REMOVING THE TRANSPORT BOLTS
ATTENTION! Before using the washing machine, the transport bolts must be
removed.
Follow these steps to remove the bolts:
1. Loosen the four transport bolts with a wrench.
2. Grasp the head of the bolt and pull it through the hole. Repeat this action for each
bolt.
3. Close the holes with the supplied plastic plugs.
4. Save the transport bolts for use during possible transport of the machine.
ADJUSTING THE LEVEL OF THE WASHING MACHINE
To eliminate vibration, set the washing machine level. If necessary, adjust the height
of the legs to compensate for the unevenness of the floor by tilting it slightly and turning
the legs.
1
2
3
4
Increase slope
Reduce slope
1. Check for the feet on the washing machine. Place the machine on a level strictly
horizontally on a flat and solid floor.
2. Adjust the position by unscrewing / screwing the legs.
3. Press the opposite corners of the washing machine from the top, make sure that the
washing machine is stable on the surface.
ATTENTION! Do not install the washing machine outdoors or in places with
temperatures below 0°C.
• The legs should be in the lowest possible position (it is not recommended to twist
them to the maximum height).
• The washing machine must stand steadily on a flat, hard floor to minimize vibration,
noise and possible movement of the machine during operation.
32
USER GUIDE