Текст страницы
2. APPLIANCE DESCRIPTION
4
1
5
6
2
7
1. The washing machine should be installed on a dry, level and hard surface.
2. Keep the appliance away from direct sunlight.
3. The washing machine should be installed in a well-ventilated room.
4. The temperature in the room should not drop below 5 °С.
5. Install the washing machine away from heat sources, such as coal or gas
ovens, fireplaces or heaters. If this is not possible, install suitable heat
insulation between the appliances, lined with aluminum foil facing the heat
source. The heat shield should cover the entire surface area of the washing
machine. The washing machine should not be heated with by the heat sources.
UNPACKING THE WASHING MACHINE
8
3
ATTENTION
9
Packaging materials (e.g. film or plastic foam) can
present a hazard for children.
SISK OF SUFFOCATION! Store the packaging
materials out of reach of children.
While unpacking the appliance ensure that it has
not been damaged during transportation. If any
damage is revealed, do not connect the machine
– immediately contact the Manufacturer (vendor).
Check the scope of supply.
- Water supply tube
- Washing agent drawer
- Door
- Top cover
- Power cable
- Control panel
- Drum
- Drain hose
- Filter
3. SCOPE OF SUPPLY
1. Remove the cardboard box and foam plastic packaging.
2. Lift the washing machine and remove the packaging from its base. Ensure that
the small foam plastic triangle is removed from the machine base. If not, lay
the appliance on a side, then manually remove the foam plastic triangle from
the bottom of the appliance.
3. Remove the tape binding the power cable to the drain hose.
4. Remove the water intake tube from the drum.
ATTENTION
Remove the four transport bolts from the back side of the machine before
operating it.
– Washing machine - 1 pc.
– Plugs - 4 pcs.
– Water supply hose - 1 pc.
– User Manual - 1 pc.
– Wrench - 1 pc.
1. Unscrew the 4 transport bolt with a suitable wrench.
2. Extract the bolts, including the rubber washers, from the machine body, keep
them in case of future transportation.
3. Close the bolt holes with the supplied plugs.
4. OPERATING THE WASHING MACHINE
INSTALLATION LOCATION
NOTE: Failure to remove the transport bolts will result in strong vibration and
noise, spontaneous displacement of the machine and can cause irreparable
damage to the machine.
LEVELING THE WASHING MACHINE
ATTENTION
– Stability is essential for preventing spontaneous displacement of the
appliance during operation.
– Ensure that the appliance is leveled out. Allowable floor gradient – 1 °.
– Ensure that the appliance is not standing on its power cable and not jamming
it.
– The minimum clearance between the appliance and the walls or adjacent
permanently fixed objects shall be 20 mm at the sides and 100 mm at the back.
Level out the washing machine using the threaded
feet so that the deviation from the horizontal plane
does not exceed 1 °.
Loosen the lock nut with a wrench.
Turn the foot until it is firmly pressed against the
floor.
Adjust all 4 feet as described in Item 2 so that the machine stands level and does
not wobble. Use a construction water level to check the leveling of the machine.
40