Текст страницы
OPERATING YOUR POLE SAW
INSTALLING THE BATTERY PACK
• Align the tongue (3) of the battery pack with the cavity.
•
• Push the battery pack into the handle until the latch locks into place.
• Do not use force when inserting the battery pack. It should slide into position and “click”.
W A R N I N G
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the pole saw.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
I M P O R T A N T
This Lithium-ion battery pack is equipped with an internal circuit breaker which will automatically
shut off the power to the tool and then reset itself once cooled.
Follow these steps if an overload occurs while under heavy use:
1. Release the power switch and restart tool by depressing switch.
2. The battery may need to be removed for approximately 1 minute, allowed to cool and then
reinstalled for use.
1
3
2
Fig. 4
14