Текст страницы
EN
3. The wiring hole is suitable for power leads with a cross-sectional area of 1.5-2.5 mm2. Strip the power
cord by 11-13 mm, and connect the neutral, live, and ground wires to the ceiling light.
11～13mm
*A solid or stranded hard
wire is used as the power
lead.
Arrange the power cord as
shown in the figure, and
check for firm wiring.
Connect the neutral, ground, and live
wires to the wiring holes marked with
N, and L in turn. (When unplugging
the power cord, press the red button on
the wiring hole first, and then pull it out).
* This product must
be grounded.
5. Once you have finished mounting, always
rotate the light body left and right and pull the
light body up and down to ensure that the lock
switch is locked in place.
4. Hold both sides of the light body with both
hands. (Be careful not to press the light-emitting
surface.)
Align the light body with the fixed base, and
gently push both sides upwards at the same time.
When you hear the "click" sound, the mounting is
complete.
Rotate left
and right
Pull up and down
Rotate left
and right
* Always check for proper mounting after
you have finished. Improper mounting
may cause the product to fall.
3