Текст страницы
Charging Time
EN
• A full charge takes approximately 4-5 hours.
• Estimated data was obtained by Tineco
Laboratory using ambient temperatures
ranging from 39.2°F (4°C) to 104°F (40°C).
Indicator
When in Use
Cleaning Mode Selection
AUTO Mode
• In AUTO mode, the iLoop sensor
automatically detects how dirty the floor
is and applies the appropriate amount of
detergent and suction power.
• A red dirt monitoring loop indicates more dirt
is detected, and a blue loop indicates less dirt
is detected. This mode automatically provides
the best cleaning solution.
Fig.C-8
Battery level ≥ 10%: battery
indicator will be illuminated.
Battery level < 10%: battery
indicator will be blinking.
Off: no power detected or
possible battery malfunction.
MAX Mode
• In AUTO mode, press the
button to enter
MAX mode. The AUTO indicator on the
display will turn off.
• In MAX mode, the appliance will apply max
suction power and will spray water/solution
for deeper cleaning.
Fig.C-9
Solid red light: dirt sensor
malfunction or blocked.
Indicator blinking: CWT is
empty.
SUCTION Mode (only available in
selected models)
• In MAX mode, press the
button to enter
SUCTION mode.
• In SUCTION mode, the appliance will
only absorb water and do not spray. We
recommend using this mode on the wet
surface.
Fig.C-10
Indicator blinking: DWT is full
or channel has a blockage.
Note:
Keep sharp objects away from the digital
display screen to avoid scratches and scrapes.
Indicator blinking: brush
roller has a blockage.
Runtime
Indicator blinking: appliance
is in need of self-cleaning.
• When in AUTO mode, the runtime is
approximately 35 minutes. When MAX power
is used, the runtime is approximately
28 minutes.
• Estimated runtime data was obtained by
Tineco Laboratory.
During Charging
Tineco indicator: breathing.
11