Текст страницы
Chapter 2
Set Up Internet Connection
2. Within 2 minutes, press the WPS button on the extender for 1 second, and the
LED
starts blinking. Wait for the
LED, 2.4GHz, 5GHz LEDs to turn solid blue, indicating
a successful connection.
Note:
If the LED does not turn solid on, try again or refer to Method 1: Via the TP-Link Tether App or Method 2: Via a Web
Browser.
3. If the extender connects to a dual band router, repeat steps 1 and 2 above to connect
to the other band. Wait until the Signal LED
turns solid on, and the setup is done.
Extended Network Names:
Router’s network name with _EXT at the end
or
Same as your EasyMesh router
Solid On
Passwords:
Same as your router
Note:
If you want to customize the extended network name, refer to Configure Wireless Network.
If you cannot find the network names with _EXT in your Wi-Fi network list, this means
that the extender has been connected to a EasyMesh router and automatically copied
its wireless settings. For more information, refer to EasyMesh with Seamless Roaming.
4. Relocate your extender for optimal Wi-Fi coverage and performance.
1 ) Plug in the extender about halfway between your router and the Wi-Fi dead zone.
The location you choose must be within the range of your router.
2 ) Wait for about 2 minutes until the Signal LED
turns solid blue. If it doesn’t,
relocate the extender closer to the router to achieve better signal quality.
Suitable location
Too far from router
No connection
Router
Devices
Halfway
Tip:
To minimize signal interference, please choose a location which is far away from Bluetooth devices and other
household electronic devices, such as cordless phones, microwave ovens and baby monitors.
5. Enjoy! Connect your devices to the extender wirelessly or via an Ethernet cable, then
enjoy the internet.
16