Текст страницы
Indicating the remaining battery capacity
NOTICE: Do not pull the switch trigger hard with-
out pressing the lock-off lever. This can cause
switch breakage.
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.6: 1. Indicator lamps 2. Check button
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever and pull the switch trigger.
The tool speed increases by increasing pressure on the
switch trigger. Release the switch trigger to stop.
Indicator lamps
Remaining
capacity
Lighted
Off
Blinking
UR002G
► Fig.8: 1. Lock-off lever 2. Switch trigger
75% to 100%
UR003G
► Fig.9: 1. Lock-off lever 2. Switch trigger
50% to 75%
Speed adjusting
25% to 50%
0% to 25%
You can select the tool speed by tapping the main
power button. Each time you tap the main power button,
the level of speed will change.
► Fig.10: 1. Speed indicator 2. Main power button
Charge the
battery.
Speed indicator
Mode
Rotation speed
High
0 - 6,500 min
-1
The battery
may have
malfunctioned.
Medium
0 - 5,300 min
-1
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Low
0 - 3,500 min
-1
Main power switch
Automatic Torque Drive Technology
Tap the main power button to turn on the tool.
To turn off the tool, press and hold the main power
button until the speed indicator goes off.
► Fig.7: 1. Speed indicator 2. Main power button
NOTE: The tool will automatically turned off if it is left
without any operations for a certain period of time.
When you turn on the Automatic Torque Drive
Technology (ADT), the tool runs at optimum rotation
speed and torque for the condition of grass being cut.
Switch action
WARNING: For your safety, this tool is equipped
with lock-off lever which prevents the tool from unin-
tended starting. NEVER use the tool if it runs when
you simply pull the switch trigger without pressing the
lock-off lever. Return the tool to our authorized service
center for proper repairs BEFORE further usage.
To start ADT, press and hold the reverse button until the
ADT indicator turns on. After that, tap the main power
button to select the cutting tool attached to the tool.
Light the lamp beside
marking to select cutter blade
and plastic blade,
marking to select nylon cutting
head.
To stop ADT, press and hold the reverse button until the
ADT indicator turns off.
► Fig.11: 1.
marking 2.
marking 3. ADT
indicator 4. Main power button 5. Reverse
button
WARNING: NEVER tape down or defeat pur-
pose and function of lock-off lever.
Indicator
Mode
Cutting tool
Rotation
speed
ADT
(Cutter blade)
Cutter blade
Plastic blade
3,500 - 6,500
min
-1
CAUTION: Before installing the battery cartridge
into the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when
released. Operating a tool with a switch that does not actuate
properly can lead to loss of control and serious personal injury.
Nylon cutting
head
3,500 - 6,500
min
-1
ADT
(Nylon cutting
head)
CAUTION: Never put your finger on the main
power button and switch trigger when carrying the
tool. The tool may start unintentionally and cause injury.
21
ENGLISH