Текст страницы
9. MAINTENANCE
GB
Maintenance Chart
Monthly
Please note that the following maintenance intervals apply for normal operating conditions only. If your daily work
requires longer than normal or harsh cutting conditions are present, then the suggested intervals should be shortened
accordingly.
As Required
If Damaged or
Faulty
Before Each Use
1 year or 100 hrs.
Complete Machine
Inspect (Leaks, Cracks, and Wear)
x
x
Clean after finishing daily work
x
Check Operation
Controls (STOP button, Choke Lever, Throttle
Trigger, Trigger interlock)
x
Inspect (Leaks, Cracks, and Wear)
Fuel Tank
Clean
x
x
Inspect
Fuel Filter and tube
Clean, Replace Filter Element
x
x
Inspect (Damage, Sharpness, and Wear)
x
Cutting Attachments
Check Tension
x
x
Sharpen
x
Bevel Gear
Inspect (Damage, Wear and Grease Level)
x
x
x
Inspect (Damage, and Wear)
Cutting Attachments Guard
Replace
x
x
x
Inspect
All Accessible Screws and Nuts (Not Adjusting Screws)
x
Retighten
x
x
Clean
Air Filter
x
x
Replace
x
Cylinder Fins
Clean
Clean after finishing daily work
x
Starter System Vents
x
Inspect (Damage, and Wear)
Starter Rope
x
Replace
Carburetor
x
Check Idle (Cutting Attachments must not
rotate at idle)
x
Check Electrode Gap
Spark Plug
x
x
Replace
x
Inspect (Damage, and Wear)
Vibration Mounts
Replace by Dealer
x
x
Cutting Attachments nuts and screws
x
Check that the locking nut of the cutting
equipment is tighten correctly
33