Текст страницы
15. TROUBLESHOOTING
GB
WARNING: Always stop unit and disconnect spark plug before performing all of the
recommended remedies below except remedies that require operation of the unit.
When all the possible causes have been checked and the problem is not resolved, consult an
Authorised Service Centre. If a problem occurs that is not listed in this table, consult an Authorised
Service Centre.
1. No spark
PROBLEM
POSSIBLE CAUSES
SOLUTION
Engine will not start or will
run only a few seconds
after starting.
2. Flooded engine.
Carburetor
requires
adjustment.
Contact a Servicing Dealer for
carburetor adjustment.
1. Watch for spark at spark plug
tip. If there is no spark, repeat
test with a new spark plug
(BPMR7A).
2. Follow procedure page 28. If
engine still fails to start, repeat
procedure with a new spark
plug.
Engine starts but will not
accelerate properly or will
not run properly at high
speed.
1. Check oil fuel mixture.
Engine does not reach full
speed and / or emits
excessive smoke
2. Air filter dirty.
3. Carburetor requires
adjustment.
1. Use fresh fuel and the correct
2-cycle oil mix.
2. Clean
per
instruction
in
Maintenance-Air Filter Section.
3. Contact a Servicing Dealer for
carburetor adjustment.
Engine starts, runs and
accelerates but will not
idle.
Carburetor
requires
adjustment.
Turn
idle
speed
screw
“T”
(Fig. 20) clockwise to increase idle
speed. See Operation-Carburetor
Adjustment.
Clutch, bevel drive or
transmission shaft damaged
Replace if necessary - contact a
Servicing Dealer.
Engine starts and runs, but
cutting attachment is not
rotating
WARNING:
Never
touch the cutting
attachment while
the
engine
is
running.
WARNING: Do not attempt to carry out repairs without the necessary repairs and
technical expertise. Poorly executed repairs will automatically invalidate the warranty and
relieve the manufacturer of all liability.
41