Текст страницы
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
GA011G
GA012G
GA013G
GA014G
GA015G
GA016G
Wheel diameter
100 mm
(4″)
115 mm
(4-1/2″)
125 mm
(5″)
100 mm
(4″)
115 mm
(4-1/2″)
125 mm
(5″)
Max. wheel thickness
6.4 mm
7.2 mm
6.4 mm
7.2 mm
Spindle thread
M10
M14 or 5/8″
(country specific)
M10
M14 or 5/8″
(country specific)
Rated speed (n)
8,500 min
-1
Overall length
with BL4025
398 mm
with BL4040
410 mm
Net weight
2.8 - 3.4 kg
3.0 - 3.6 kg
2.8 - 3.3 kg
2.9 - 3.5 kg
2.9 - 3.6 kg
Rated voltage
D.C. 36 V - 40 V max
•
Due to our continuing program of research and development, the specifications herein are subject to change without notice.
•
Specifications may differ from country to country.
•
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
BL4025 / BL4040
Charger
DC40RA
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Noise
The typical A-weighted noise level determined according to EN60745-2-3:
Model
Sound pressure
level (LpA) : (dB(A))
Sound power level
(LWA) : (dB(A))
Uncertainty (K) :
(dB(A))
GA011G
81
92
3
GA012G
81
92
3
GA013G
82
93
3
GA014G
81
92
3
GA015G
81
92
3
GA016G
82
93
3
NOTE: The declared noise emission value(s) has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be used in a preliminary assessment of exposure.
WARNING: Wear ear protection.
WARNING: The noise emission during actual use of the power tool can differ from the declared val-
ue(s) depending on the ways in which the tool is used especially what kind of workpiece is processed.
WARNING: Be sure to identify safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
7
ENGLISH