Текст страницы
Operation with wheel/disc
Installing or removing dust cover
attachment
► Fig.28
Optional accessory
CAUTION: Always be sure that the tool is
switched off and unplugged before installing or
removing the dust cover attachment. Failure to do
so causes damage to the tool or a personal injury.
Turn the tool on and then apply the wheel or disc to the
workpiece.
In general, keep the edge of the wheel or disc at an
angle of about 15° to the workpiece surface.
During the break-in period with a new wheel, do not
work the grinder in forward direction or it may cut into
the workpiece. Once the edge of the wheel has been
rounded off by use, the wheel may be worked in both
forward and backward direction.
Install the dust cover attachment to each specified
position.
For details, refer to the instruction manual of the dust
cover attachment.
Operation with abrasive cut-off /
diamond wheel
Optional accessory
NOTICE: Clean out the dust cover attachment
when it is clogged with dust or foreign matters.
Continuing operation with a clogged dust cover
attachment will damage the tool.
OPERATION
WARNING: Do not "jam" the wheel or apply
excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel
increases the loading and susceptibility to twisting
or binding of the wheel in the cut and the possibility
of kickback, wheel breakage and overheating of the
motor may occur.
WARNING: It should never be necessary to
force the tool. The weight of the tool applies ade-
quate pressure. Forcing and excessive pressure
could cause dangerous wheel breakage.
WARNING: ALWAYS replace wheel if tool is
dropped while grinding.
WARNING: Do not start the cutting operation
in the workpiece. Let the wheel reach full speed
and carefully enter into the cut moving the tool
forward over the workpiece surface. The wheel
may bind, walk up or kickback if the power tool is
started in the workpiece.
WARNING: NEVER hit the workpiece with the
wheel.
WARNING: During cutting operations, never
change the angle of the wheel. Placing side pres-
sure on the cut-off wheel (as in grinding) will cause
the wheel to crack and break, causing serious per-
sonal injury.
WARNING: Avoid bouncing and snagging
the wheel, especially when working corners,
sharp edges etc. This can cause loss of control and
kickback.
WARNING: A diamond wheel shall be oper-
ated perpendicular to the material being cut.
WARNING: NEVER use tool with wood cutting
blades and other saw blades. Such blades when
used on a grinder frequently kick and cause loss of
control leading to personal injury.
Usage example: operation with abrasive cut-off
wheel
► Fig.29
WARNING: Continued use of a worn-out
wheel may result in wheel explosion and serious
personal injury.
Usage example: operation with diamond wheel
► Fig.30
Operation with wire cup brush
CAUTION: Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
Optional accessory
CAUTION: Always wear safety goggles or a
face shield during operation.
CAUTION: Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION: After operation, always switch off
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
Usage example: operation with wire cup brush
► Fig.31
CAUTION: ALWAYS hold the tool firmly with
one hand on housing and the other on the side
grip (handle).
NOTICE: Avoid applying too much pressure
which causes over bending of wires when using
brush. It may lead to premature breakage.
NOTE: A dual purpose wheel can be used for both
grinding and cutting-off operations.
Refer to the "Operation with wheel/disc" for grinding
operation, and refer to the "Operation with abrasive
cut-off / diamond wheel" for cutting-off operation.
18
ENGLISH