Текст страницы
ADDITIONAL SAFETY RULES
SERVICE
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
ADDITIONAL SAFETY RULES
Special safety instructions for grinding and abrasive cutting:
a) This power tool is to be used as a grinder and abrasive cutting appliance. Please follow all
safety instructions, instructions, diagrams and data that you receive with the appliance.
If you do not observe the following instructions, this can lead to an electrical shock, fire
and/or serious injuries.
b) This power tool is not suitable for sandpaper sanding, working with a steel brush or
burnishing. Using the power tool for applications for which it is not designed can lead to
hazards and injuries.
c) Do not use any accessories that have not been specifically provided or recommended
by the manufacturer for this power tool. Just because you can attach the accessories to
your power tool does not guarantee they are safe to use.
d) The maximum speed of the accessory tool used must be at least as high as the maximum
speed specified for the power tool. Accessories that rotate faster than the permissible rate
can break and throw pieces into the air.
e) The external diameter and thickness of the accessory tool used must comply with the
dimensions of the power tool. Incorrectly dimensioned accessory tools cannot be
ufficiently shielded or controlled.
f) Attachment tools with a thread insert must match the thread of the grinding spindle
exactly. For attachment tools that are mounted using a flange, the diameter of the hole on
the attachment tool must correspond to the width of the fitment on the flange. Accessory
tools that cannot be fitted precisely to the power tool rotate unevenly, vibrate severely and
can lead to a loss of control.
g) Never use damaged attachment parts. Check accessory tools such as grinding discs
before each use for chips or cracks, grinding plates for cracks, wearing or excessive wear
and tear and wire brushes for loose or broken wires. If the power tool or the accessory tool
in use is dropped, check to see if it is damaged or use an undamaged accessory tool. When
you have checked and inserted the accessory tool, ensure that you and any other people in
the vicinity remain outside of the level of the rotating accessory tool and allow the tool to
rotate at maximum speed for one minute. Damaged accessories usually break during the
test period.
h) Wear personal protective equipment. Depending on the application, ensure that you
use full face protection, eye protection or goggles. Use a dust mask, hearing protection,
protective gloves or special apron to protect yourself from grindings and material particles
as required. Protect your eyes from flying debris that may be created during certain
EN
5