Текст страницы
8
EN
• After you finish ironing, set the temperature control
knob (12) to the «MIN» position.
• Disconnect the power plug from the mains socket and
wait until the iron soleplate (11) cools down completely.
Note: when switching the unit on for the first time, foreign
smell can appear. It is normal.
• After you finish ironing, set the temperature control
knob (12) to the position «MIN», and the continuous
steam supply knob (3) to the position «
» (steam
supply is off).
• Disconnect the power plug from the mains socket
and wait until the iron soleplate (11) cools down
completely.
STEAM IRONING
The iron is equipped with anti-drip valve that stops water
supply, if the soleplate (11) temperature is too low, it
prevents dripping from the soleplate (11) openings.
ATTENTION! If steam is not supplied during the
operation, check whether the temperature control knob
(12) and the steam supply knob (3) are set properly and
whether there is water in the water tank (10).
WATER SPRAY
Steam ironing is possible only if the temperature control
knob (12) is set to the steam mode «•••» or «MAX».
• Make sure that there is enough water in the water
tank (10).
• Press the water spray button (5) to dampen the
fabrics.
BURST OF STEAM
• The burst of steam is useful for ironing folds and can
be used only in the high temperature ironing mode;
set the temperature control knob (12) to the position
«•••» or «MAX».
• When pressing the burst of steam button (4) steam
will go out of the iron soleplate (11) openings
intensively.
Note: to avoid water leakage from the soleplate (11)
openings, press the burst of steam button (4) with 4-5
sec. intervals.
• Place the iron on its base (9).
• Insert the power plug into the mains socket.
• Make sure that there is enough water in the water tank
(10).
• Turn the control knob (12) to set the required ironing
temperature in the steam mode «•••» or «MAX», the
indicator (7) will light up.
• When the temperature of the soleplate (11) reaches the
set point, the indicator (7) will go out and you can start
ironing.
• Set the necessary steam intensity with the continuous
steam «
,
» supply knob (3): steam will be released
from the openings of the soleplate (11) only if the iron is
in horizontal position. To stop the steam supply, put the
iron vertically or set the knob (3) to the position «
»
(steam supply is off).