Текст страницы
ENGLISH
Control knobs, indications and symbols
••
The steam supply knob (3) has 3 fixed positions:
– the steam supply is off (utmost left posi
Attention! Do not allow children to play with poly
ethylene bags or packaging film. Danger of suf
focation!
tions);
– the steam supply is on (middle);
– maximal steam supply (utmost right posi
tions).
••
«CLEAN» button (15) – self-clean.
••
Burst of steam button (4) – press the button to
activate the additional steam supply function.
••
Water spray button (5) – press the button to
activate the water spray function.
••
Heating element ON/OFF indicator (7). When
the indicator (7) glows, the iron soleplate (13)
heats up.
••
Temperature control knob (11) – allows to set
the iron soleplate temperature depending on
the type of fabric. The knob is in the position
«OFF» – the iron is off.
••
«max» (12) maximal water level mark.
WATER SELECTION
You can use tap water to fill the water tank (10).
If tap water is hard, use distilled or demineralized
water, this will prolong service life of the iron.
Note: Do not fill the water tank (10) with scented
liquids, vinegar, starch solution, descaling
reagents, chemical agents etc.
••
This unit is not intended for usage by children.
Place the unit out of reach of children during
operation and cooling down.
••
The unit is not intended to be used by peo
ple with physical, sensory or mental disabilities
(including children) or by persons lacking expe
rience or knowledge if they are not under super
vision of a person who is responsible for their
safety or if they are not instructed by this person
on the usage of the unit.
••
Do not use the unit if the power cord or the
power plug is damaged. If the power cord is
damaged, it should be replaced by the manu
facturer, service or similar qualified personnel
to avoid danger.
••
Do not use the iron after it was dropped, if there is
visible evidence of damage or if the iron is leaking.
••
Do not attempt to repair the unit. Do not disas
semble the unit by yourself, if any malfunction is
detected or after it was dropped, unplug the unit
and apply to any authorized service center from
the contact address list given in the warranty
certificate and on the website www.vitek.ru.
••
Transport the unit in the original package only.
••
Keep the unit out of reach of children and dis
abled persons.
FILLING THE WATER TANK
Before filling the iron with water, make sure that it
is unplugged.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY. ITS COMMERCIAL USAGE AND USAGE
IN PRODUCTION AREAS AND WORK SPACES IS
PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage at low tem
perature keep it for at least three hours at room
temperature before switching on.
••
Set the temperature control knob (11) to the
«OFF» position and the continuous steam sup
ply knob (3) to the leftmost position (steam
supply is off).
••
Open the water inlet lid (2).
••
Pour water into the water tank (10) using the
beaker (14) and then close the lid (2) tight.
Note:
– Do not exceed the «max» mark (12).
– If you need to refill water during ironing, always
switch the iron off first and unplug it.
– After you finish ironing, switch the iron off, wait
until it cools down completely, then open the
water inlet lid (2), turn over the iron and drain
the remaining water.
– Set the steam iron to the vertical position on
••
Unpack the iron; remove the protection from the
soleplate (13), if any.
••
Check the unit for damages, do not use the iron
in case of damages.
••
Before switching the iron on, make sure that
your home mains voltage corresponds to the
iron operating voltage.
••
There may be water residue in the tank, this is
normal, as the iron has undergone factory qual
ity control.
Note: While the first switching on the heating ele
ment of the iron burns, therefore occurrence of
foreign smell and a small amount of smoke is pos
sible, it is normal.
the base (9), insert the plug into the mains
socket and set the temperature control knob
to the maximal position, let the iron heat for
2 minutes. Disconnect the steam iron from the
mains.
10