Текст страницы
Maintenance and Care
Warning: Be sure to turn off and unplug the device before performing the following operations.Keep the unit upright when cleaning the device.
Cleaning the Device
Cleaning the Pump
After removing the unit and the filter, take out the water
collector from the water tank and turn it over. Brush the
pump gently with a soft brush.
A reasonable amount of food-grade citric acid detergent
is recommended for cleaning and removing sediment
from the water tank, the transparent winder, and the filter.
In general, it is recommended that you allow the max
mode to run for approximately 15 minutes (though this can
be shortened or lengthened depending on the actual
conditions).Rinse the water tank, water collector, and filter
with clean water once you have finished.
Water Collector
Notes:
To avoid damaging the device during the cleaning process, ensure that
the temperature of the water used to clean the device does not exceed
35°C.
To avoid damaging the device, do not use detergents that are highly
acidic or alkali-based or other highly corrosive cleaning solutions.
Cleaning the Transparent Window
Remove the unit and place it on a horizontal table. While
holding the device with one hand, use your other hand to
wipe the inner wall of the transparent window gently with
a soft cloth.
Pump
Note: Rinsing the unit is prohibited. Before wiping the unit, wring out the
soft cloth thoroughly to avoid damaging from excess water.
09