Текст страницы
IM2022
a while.
No atomizing
The power cord is poorly
connected to the outlet
White patches have
formed on the membrane
Use filtered water
Connect the power cord
into
the outlet carefully
There is white patches
from the water on objects
around the humidifier
(salts, separating out from
water)
Clean the humidifier’s
membrane with a special
brush
There is a lot of salts in the
water (calcium and
magnesium)
Steam has a bad smell
Stale water is used
Clean the unit according to
the cleaning and servicing
instructions and fill the tank
with fresh and filtered
water
High humidification
intensity is set.
Decrease the
humidification
intensity
Room humidity and
room temperature are high
Remains of stale water or
waste have accumulated in
the unit’s case or the
atomizer
During the operation of the
device, condensate is
forming on the upper part
of the humidifier
and on surrounding
objects
High humidification
intensity is set.
Decrease the
humidification
intensity
During the operation of the
device water appears next
to it
The water tank is badly
installed on the unit’s base
and there is a gap between
them.
Turn off the unit and make
sure the water tank is
installed correctly on the
base, without any gaps
between the tank and the
base.
White patches have formed
on the membrane and in
grooves for water (in the
unit’s base).
Clean the unit according to
the cleaning and servicing
instructions.
Water appears next to the
humidifier, when it is off
Water tank is leaking
Contact an
authorized service center
11. STORAGE
Before storage make sure that the appliance is disconnected from power source.
Perform all actions described in "CLEANING AND MAINTENANCE" section.
Wash and dry the appliance, place it in the original package and store in a dry
place.
12. UTILIZATION RULES
After the lifetime of the device expires, it should be recycled in compliance
with the laws, rules and methods in region of recycling. Detailed information
about the recycling of the device, you can receive from a representative of the
local authorities, after providing full information about the device. The
manufacturer and authorized organization of the manufacturer do not carry
responsibility for the fulfillment by the Buyer of the requirements of legislation on
utilization and methods of utilization of the device selected by the Buyer. The lifetime of
25