Текст страницы
Installing the rear wheel on single-speed bikes
When installing the rear wheel on single-gear bicycles, it is necessary to ensure optimum chain
tension. Too low a tension can cause the chain to drop from the sprockets, and too much tension
will result in a difficult travel and excessive wear on the chain.
— Loosen the nuts.
20-25 mm
— The normal tension of the chain should be
such that its lower branch has a slight sag when
pulling the upper branch by hand. The deviation
in the middle part should be 20 - 25 mm.
Installation of support wheels on children’s bicycles
— To install the support wheels, you must first remove the nuts and washers from the rear wheel
axle without removing the nut that secures the rear wheel to the dropouts.
— Under the weight of the bicycle, the wheel itself will fit
exactly in the landing ends of the fork.
— Then install the brackets with support wheels on the rear axle. The ledge of the bracket should
enter the groove of the dropout. Support wheels should be installed at a distance of 1 -1.5 cm
from the ground. When checking the indicated value, the bike must be strictly upright. Wheel
height above ground level is adjusted by moving the brackets up / down (special elongated
holes are provided in the brackets).
— Tighten the nuts first with a little effort to precisely fix the
wheel, then tighten the nuts with the recommended force.
1-1,5 mm
— After the support wheels are set to the required height, you should install the washers and
fasten the brackets to the axles with nuts.
Removing / installing wheel with V-Brake
— To remove / install the wheel with V-Brake type, release /
engage the brake coupler.
67
66