Текст страницы
Torque Nm
Front axle nuts
20–27
Rear axle nuts
27–35
Axle cone locknuts
10–25
opening
the lock
Threaded ratchet
35–50
Pedals
35–40
Connecting rod bolts
30–50
key to opening the lock
Gear Bolts (Bonks) Steel
8–12
Gear Bolts (Bonks) Aluminum
5–10
Cartridge Type Carriage
50–70
Adjustable carriage
70–80
Attaching Trigger Shifters
6–8
Front Clamp
5–7
closing
the lock
Cable clip in front derailleur
5–7
Rear derailleur mount
8–10
Cable clamp in rear derailleur
4–6
key to closing the lock
Bolts of rollers of the back switch
3–4
Attaching the brake levers to the frame
6–8
Brake pads
5–7
Bike storage
Between trips, keep your bike in a place with normal humidity, protected from sun and rain.
Use special detergents to clean the bike frame and parts. Improper use ofcleaning products can
damage the coating and material of parts.
Cable clamp
6–8
Brake disc (rotor)
2–4
Brake caliper
6–8
Hydraulic Line Fittings
5–7
5. TECHNICAL INFORMATION ASSEMBLY AND TUNING
OF THE BICYCLE
Expansion tank cap screws
0.3–0.5
Threaded-type steering
5–8 (М5), 10–14 (М6)
Threaded steering
17–20
One bolt, 6 mm Allen key
17–28
Two bolts, 5 mm Allen key
10–14
Two bolts, 4 mm Allen key
5–7
One stud with nuts, open-end wrench 13 or 14 mm
20–25
Be sure to read this section of the Guide, since it is important to have an idea of how the various
parts and components of the bike are arranged and work.
If you have questions regarding the device and the functioning of any part, contact the seller
for clarification.
Attention! All assembly, tuning and repair work of the bicycle must be carried out by a
qualified bicycle mechanic at the place of purchase of the bicycle, in one of the author-ized
service centers or in a specialized bicycle workshop using professional equipment and tools
in compliance with the technological requirements of component manufactur¬ers (tightening
torques, see page 40) In case of independent and unqualified repair of the bicycle, the warranty
shall cease to be valid (see the «Warranty Information» section).
Tightening for threaded connections
Always use a calibrated torque wrench to tighten threaded connections. Before using the key,
be sure to read the manufacturer’s instructions.
The correct tightening torque for threaded connections is an important factor in your safety.
Always tighten all connections with the correct force.
63
62