Текст страницы
IM022
Do not attempt to repair, adjust or replace parts in the
appliance. Repair the malfunctioning appliance in the nearest service center.
If the product has been exposed to temperatures below 0ºC for
some time it should be kept at room temperature for at least 2 hours before turning it on.
The manufacturer reserves the right to introduce minor changes
into the product design without prior notice, unless such changes influence significantly the product safety, performance, and functions.
Manufacturing date is indicated on the unit and/or on packing
as well as in accompanying documents in the following format
XX.XXXX where first two figures XX is the month of production,
and following four figures XXXX is the year of production.
ASSEMBLING INSTRUCTIONS:
The device is intended for air circulation in the room.
Fan is packed disassembled. Before assembling make sure that all the required parts are
undamaged and included into the set.
Do not plug in the device before its assembling is finished.
Tighten stand tube to stand base with screw. Fix base cover to stand base with a screw
(supplied with a set).
Unscrew out-joint, put the stand cover and base cover on the stand base, pull the extension
pole out then tighten the out-joint again.
Place control box firmly on top of extension pole, tighten screw B.
Unscrew the blade cap by turning clockwise and rear grill nut by turning counter clockwise and
put both blade cap and rear grill nut off the motor shaft.
Put rear grille on motor shaft.
Secure it with rear grille nut.
Slide blades on motor shaft so that claws on motor shaft match the blades slots.
Screw blade cap on shaft by turning counter clockwise.
Put front grille on rear grille and close clips or screw grille ring to secure grilles together.
Adjust the fan vertically by vertical adjustment screw.
The fan is ready for work.
OPERATION MANUAL
CAUTION: To avoid electroconvulsive shock or fire danger, do not operate fan under the
conditions of increased humidity.
Place fan only onto dry flat unyielding surface.
The fan can work in three speed modes:
- “1”
For minimum operational speed;
- “2”
For medium operational speed;
- “3”
For maximum operational speed;
- “0”
The fan is switched off;
On the upper part of the motor cover there is oscillating knob. If pressed, it makes the fan
cabinet with blades traverse from side to side. To cancel oscillating mode push oscillating knob
upward.
To switch the fan off push the button “0”
MAINTENANCE
Before cleaning unplug fan first.
Clean front and rear grilles, blades, stand tube and stand base with soft moistened cloth and
wipe dry.
Do not use abrasive cleansers
STORAGE
Keep the device in normal conditions in dry place.
The symbol on the unit, packing materials and/or documentations means used electrical
and electronic units should not be toss in the garbage with ordinary household garbage. These
units should be pass to special receiving point.
For additional information about actual system of the garbage collection address to the local
authority.
Valid utilization will help to save valuable resources and avoid negative work on the public
health and environment which happens with incorrect using garbage.
www.scarlett.ru
SC-SF111B36
12