Текст страницы
IM021
Unscrew out-joint, put the stand cover and base cover
with blades traverse from side to side. To cancel
oscillating mode push oscillating knob upward.
MAINTENANCE
on the stand base, pull the extension pole out then
tighten the out-joint again.
Place control box firmly on top of extension pole,
tighten screw B.
Unscrew the blade cap by turning clockwise and rear
Before cleaning unplug fan first.
Do not use abrasive cleansers
Clean front and rear grilles, blades, stand tube and
stand base with soft moistened cloth and wipe dry.
STORAGE
Keep the device in normal conditions in dry place.
grill nut by turning counter clockwise and put both
blade cap and rear grill nut off the motor shaft.
Put rear grille on motor shaft.
Secure it with rear grille nut.
Slide blades on motor shaft so that claws on motor
shaft match the blades slots.
Screw blade cap on shaft by turning counter
clockwise.
Put front grille on rear grille and close clips or screw
The symbol on the unit, packing materials and/or
documentations means used electrical and electronic
units should not be toss in the garbage with ordinary
household garbage. These units should be pass to
special receiving point.
For additional information about actual system of the
garbage collection address to the local authority.
Valid utilization will help to save valuable resources
grille ring to secure grilles together.
Adjust the fan vertically by vertical adjustment screw.
The fan is ready for work.
OPERATION MANUAL
CAUTION: To avoid electroconvulsive shock or fire
danger, do not operate fan under the conditions of
increased humidity.
and avoid negative work on the public health and
environment which happens with incorrect using
garbage.
Place fan only onto dry flat unyielding surface.
BUTTONS:
ON/OFF button switches on the power/ button
switches the fan off.
Speed button switches the fan on and shifts between
different speeds
Mode button helps to choose operating mode of fan.
Nor (normal) - air stream at constant rate
Nat (nature) - air stream by intense waves
Slp (sleep) - air stream by weak waves
Timer button helps to adjust fan operating time up to
maximum time of 7 hours and a half. Each pressing of
this button adds half an hour of fan operating time.
For example, if you wish to set operating time of 5
hours and a half, you need to do the following: Press
the button “Timer” several times and see on display:
0.5h, 1h, 4h, that means you have set 5.5h
LIGHT INDICATORS:
0.5h…4h - fan operating time set
Nor - air stream at constant rate
Nat - air stream by intense waves
Slp - air stream by weak waves
H – high speed;
M – middle speed;
L – minimum speed;
REMOTE CONTROLLER:
Mode settings can be made manually by using switch
mode buttons on control box or by using remote
controller:
ON/OFF button switches on the power/ button
switches the fan off.
Speed button switches the fan on and shifts between
different speeds.
Mode button helps to choose operating mode of fan.
Nor (normal) - air stream at constant rate
Nat (nature) - air stream by intense waves
Slp (sleep) - air stream by weak waves
Timer button helps to adjust fan operating time. Each
pressing of this button adds half an hour of fan
operating time.
NOTE: Remote controller operates on AAА 1.5V batteries
which are not included.
On the upper part of the motor cover there is
oscillating knob. If pressed, it makes the fan cabinet
www.scarlett.ru
8 SC-SF111RC09