Текст страницы
2. Push the fan blade onto the motor shaft by aligning the slots on the base of the
fan blades with the shaft pin. Tighten the fan blades with the fan blade lock. This
lock must be tightened counterclockwise. Check that the fan blades rotate freely
by slightly turning them.
3. Open the securing clip and loosen the screw on the lower side of the front safety
guard. Position the front guard at the upper side of the rear guard. Press the front
guard onto the rear guard and close the securing clip. Tighten the crew.
Functions
shine.
ON/OFF
The device starts at low speed. The symbol I and
By pressing this button you can change the ventilation performance:
∙∙Level II – medium
∙∙Level III – fast
The device runs continuously.
Setting the time from 1 – 7 hours.
After the time run out, the device turns off.
Oscillation
Function mode
Uninterrupted service
Interval ventilation
This setting should simulate natural winds. The different wind flows
repeat every 60 seconds as long as the set time runs out.
Level I: low airflow
Level II: medium airflow
Level III: high airflow
Sleeping mode
The tilt angle can be adjusted.
12