Текст страницы
IM2021
6. DELIVERY SET
- Stand fan - 1 pc.
- Instruction manual - 1 pc.
- Warranty card - 1 pc.
- Packing - 1 pc.
- ASSEMBLING INSTRUCTIONS
Fan is packed disassembled. Before assembling make sure that all the required
parts are undamaged and included into the set.
Do not plug in the device before its assembling is finished.
Tighten stand tube to stand base with screw. Fix base cover to stand base with a
screw (supplied with a set).
Unscrew out-joint, put the stand cover and base cover on the stand base, pull the
extension pole out then tighten the out-joint again.
Place control box firmly on top of extension pole, tighten screw B.
Unscrew the blade cap by turning clockwise and rear grill nut by turning counter
clockwise and put both blade cap and rear grill nut off the motor shaft.
Put rear grille on motor shaft.
Secure it with rear grille nut.
Slide blades on motor shaft so that claws on motor shaft match the blades slots.
Screw blade cap on shaft by turning counter clockwise.
Put front grille on rear grille and close clips or screw grille ring to secure grilles
together.
Adjust the fan vertically by vertical adjustment screw.
The fan is ready for work.
8. OPERATION MANUAL
CAUTION: To avoid electroconvulsive shock or fire danger, do not operate fan under
the conditions of increased humidity.
Place fan only onto dry flat unyielding surface.
The fan can work in three speed modes:
- “1”
For minimum operational speed;
- “2”
For medium operational speed;
- “3”
For maximum operational speed;
- “0”
The fan is switched off;
On the upper part of the motor cover there is oscillating knob. If pressed, it makes
the fan cabinet with blades traverse from side to side. To cancel oscillating mode
push oscillating knob upward.
To switch the fan off push the button “0”
13