Текст страницы
Square Sander
rate level and the contact pressure.
Only immaculate sanding sheets achieve
good sanding performance and make the
power tool last longer.
Be sure to apply consistent contact pressure
in order to increase the lifetime of the sanding
sheets.
Excessively increasing the contact pressure
will not lead to increased sanding perfor-
mance, rather it will cause more severe wear
of the power tool and of the sanding sheet.
Do not use a sanding sheet for other materi-
als after it has been used to work on metal.
Use only original P.I.T sanding accessories.
Maintenance and Service
Maintenance and Cleaning
►Pull the plug out of the socket before
carrying out any work on the power
tool.
►To ensure safe and effi cient operation,
always keep the power tool and the
ventilation slots clean.
In order to avoid safety hazards, if the power
supply cord needs to be replaced, this must
be done by P.I.T. or by an after-sales service
centre that is authorised to repair P.I.T. power
tools.
Dispose of waste
Damaged power tools, batteries, acces-
sories and waste packaging materials must
be recycled and reused in an environmentally
friendly manner.
Do not throw power tools and accumulators /
batteries into general household waste!
Product serial number interpreta-
tion serial number
The fi rst and second digits of the product seri-
al number from left to right
Year of production, the third and fourth digits
indicate the month of production
The fi fth and sixth digits indicate the produc-
tion day.
TERMS OF WARRANTY SERVICE
1. This Warranty Certifi cate is the only docu-
ment that confi rms your right to free warranty
Open the clamping lever.
Place the sanding sheet fi rmly on the sanding
platform. Slide the other end of the sanding
sheet under the open front clamping bar and
clamp the sanding sheet with the clamping
lever.
To remove the sanding sheet, release the
clamping lever and press down. Remove the
sanding sheet.
Special sanding platforms
You can replace the supplied sanding platform
with an optional special sanding plate.
The installation of a special sanding plate is
carried out in the same way as the platforms
in the kit.
Fitting and removing the corresponding sand-
ing paper is done in the same way as when
changing the original sanding paper.
Operation
Starting Operation
►Pay attention to the mains voltage.
The voltage of the power source must
match the voltage specifi ed on the rat-
ing plate of the power tool. Power tools
marked with 230 V can also be operated
with 220 V.
Switching on/off
►Make sure that you are able to press
the On/Off switch without releasing the
handle.
To switch on the power tool, press and hold
the on/off switch.
To lock the on/off switch press and hold it
while also pushing the lock-on button.
To switch off the power tool, release the on/
off switch.
If the on/off switch is locked, press the switch
fi rst and then release it.
Preselecting the orbital stroke rate
You can even preselect the orbital stroke rate
during operation using the necessary orbital
stroke rate preselection thumbwheel.
The required orbital stroke rate is dependent
on the material and the work conditions and
can be determined using practical tests.
Practical advice
►Pull the plug out of the socket before
carrying out any work on the power
tool.
►Always wait until the power tool has
come to a complete stop before placing
it down.
The material removal rate and sanding result
are primarily determined by the choice of
sanding sheet, the preselected orbital stroke
7