Текст страницы
For tool with shallow driver bit hole
A=12mm
B=9mm
Use only these type of driver
bit. Follow the procedure
1. (Note) Bit-piece is not
necessary.
NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
For tool with deep driver bit hole
NOTE: When it is difficult to insert the driver bit, pull
the sleeve and insert it into the sleeve as far as it will
go.
A=17mm
B=14mm
To install these types of driver
bits, follow the procedure 1.
NOTE: After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.
A=12mm
B=9mm
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.
Installing hook
Procedure 1
For tool without one-touch type sleeve
CAUTION: When installing the hook, always
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
1
1
2
1
2
2
3
3
► 1. Driver bit 2. Sleeve
► 1. Groove 2. Hook 3. Screw
To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
For tool with one-touch type sleeve
To install the driver bit, insert the driver bit into the
sleeve as far as it will go.
Procedure 2
Optional accessory
OPERATION
In addition to Procedure 1, insert the bit-piece into the
sleeve with its pointed end facing in.
3
1
2
► 1. Driver bit 2. Bit-piece 3. Sleeve
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
8
ENGLISH